How to "manually" change the key in MultiCASu ...

What I do when you change a key, not that we will change the whole MultiCAS emulator, under the assumption that the key to well-known and published on the net?

Go - eg. - To our department for ključićem, find the key in the relevant section and now ...

Press HOME key on the remote -> Plugins -> OpenXCAS -> Activation & Priority Settings -> that put the # in front of everyone and cancel it before MultiCAS EMUa.

That leaves the Exit Menu key -> Camd Setup -> OK -> MultiCAS -> Book And Convert Keys, and in the sub-menu Nagravision -> right arrow on the remote, then arrow down to the Digi TV nadjem -> identity [ 2011 - Warning: the Dream, and so on Humax receivers identity is 2111, but let it not Rebellion!] -> and then insert the key.

Here's the key 00 is active. It must be two times slip, since the keys in two of the "broken": the first part of the USA 00 and the second 10, the key 00, and 01 and 11 for the key 01.

So, clicking on the appropriate part of key [in this case 00 20 11 00] with the OK key on the remote and then you get a new window that editiras old key. Ubacis first part, then Save, then second [in this case 00 20 11 01], then Save, and izadjes from this sub-menu, go to Activation & Priority Settings, restartas MultiCam zutim key, then izadjes from all this through the Home keys -> TV -> OK .... IIII [if it is the key to a good and precise you put ga] - gledaaaaassssss ...

So while going - ideeeee ....

Cheers and good luck!