titanium2 with os 3.01 for nova cy and gr

[ermisvk77]

something new file for tita?????

[cascadero]

why? Two of the old ones work very well if you send logs to the card

[maria_1981]

i am new to the titan card, what do you mean send logs to the card? I have passed the code 28022010 but it doesnt work.
Do i do something wrong?

[pouro]

mchellas_20100213_28 1Std Cinema 1 receiver aus receiver an ok. GR+CY

[humidream]

mchellas_20100213_28 1Std Cinema 1 receiver aus receiver an ok. GR+CY

How will write the titanium 3 on this file, with T3loader?
Because 3 files include.

Thanks!

[cascadero]

For all new ones, here's how it works with cas3plus


0. cas3plus has to be connected via serial port (no usb to serial adapter)
1. start cas3plus application
2. switch to phoenixmode 3,68mhz
3. start titaniumloader.exe (in my opinion the best of the three loaders) (you can also use t3loader it is a bit easier cause it loads the thre files automatically from the selected folder, but for me it does not work very well cause it often has problems erasing cards properly)
4. connect card (if its empty you will get a message: "Titanium2 OS 31. found" if the card has a file on it you will get: "Unsupported Titanium OS found"
4. erase card (not necessary if its new) you will get an error message "restore failed" this means nothing
5. reset card and you get: "Titanium2 OS 31. found"
6. Load each of the three files in the filefolder (flashex, eeprom and crypthex)
7. Then burn the card
that's all

If you just look around some forums you will find a lot of files

[Roulitsas]

Although this is an English section, you write in Greek. Anyway... it is confirmed that none all the usb-2-serial adapters can write the Tita with the Phoenix programmer. Actually only FTDI chipsets are able to work with Tita (like the Digitus USB2Serial shown above) and not the PL2303 cables/adapters. Try to find which one is yours by looking at the Device Manager of your Windows.

[pelopas]

sorry guys for my mistake.

[pelopas]

Although this is an English section, you write in Greek. Anyway... it is confirmed that none all the usb-2-serial adapters can write the Tita with the Phoenix programmer. Actually only FTDI chipsets are able to work with Tita (like the Digitus USB2Serial shown above) and not the PL2303 cables/adapters. Try to find which one is yours by looking at the Device Manager of your Windows.

I confirmed that Roulitsas.

[mrmatchris]

Sorry for my mistake too. I didn't noticed were I was....