Mvision firm chat

[giwrgosp]

Hi to all.
I upgraded Hispania MVision FCIS 7000 with the new firmware version 2.80 and when i tried to restart my receiver there was a message "ERR.0"
And now i can't connect my pc with the receiver. The loader 1.2 for MVision shows a message that can't establish connection.
What should i do? Please help me

[mouloud123]

Hi to all.
I upgraded Hispania MVision FCIS 7000 with the new firmware version 2.80 and when i tried to restart my receiver there was a message "ERR.0"
And now i can't connect my pc with the receiver. The loader 1.2 for MVision shows a message that can't establish connection.
What should i do? Please help me

Hello all

ih you have "ERR.0" start boxloader and make updrade software (don't make "setup comm" : connection error!!) and choose a good firmware (not mv2.80 thanks for fake files ). Now my fcis 7000 works with the firm 2.79.
Thats all

Good bye

[giwrgosp]

Hello all

ih you have "ERR.0" start boxloader and make updrade software (don't make "setup comm" : connection error!!) and choose a good firmware (not mv2.80 thanks for fake files ). Now my fcis 7000 works with the firm 2.79.
Thats all

Good bye

YES!!!! Its work!!! Thanks.. Thanks!!! Thanks!!!!!

[mouloud123]

YES!!!! Its work!!! Thanks.. Thanks!!! Thanks!!!!!

no problem man

have a nice day

[meguel]

Attention to all.

2.80 MV firmware is FAKE.

Is the mdr 2.61 renamed 2.80 MV

Don't upload this.

Thank you so much for this info...

[tinial]

Hello all

ih you have "ERR.0" start boxloader and make updrade software (don't make "setup comm" : connection error!!) and choose a good firmware (not mv2.80 thanks for fake files ). Now my fcis 7000 works with the firm 2.79.
Thats all

Good bye

hi friend,where can I find 2.79 mv or mt fcis 7000 and what's new in 2.79?
thanks

[mouloud123]

hi friend,where can I find 2.79 mv or mt fcis 7000 and what's new in 2.79?
thanks

Hello i make a mistake i have the firm 2.78 sorry man
excuse me
have a nice day

[tinial]

Hello i make a mistake i have the firm 2.78 sorry man
excuse me
have a nice day

thanks man for your response

[meguel]

My Dear M8s,

I upgraded the bootloader of my Mvision FCIS7000 with the one included in the firmware version r2.55 in order to use the Mvision E+ firmware.... The upgrading was successful unfortunately my remote control did not works... does anybody here encounter the same problem as what i have now? What shall I do? where i can buy new remote control compatible with the Mvision E+ Firmware. Hoping for your help guys.

Thank you so much in advance for your help.

regards,
meguel

[GUSJA]

My friend try to change the batteries.

It's not depend of firmware.

I suggest to you to upload the 2,78 firmware on your stb. Then try again with remote control