ja paska nis me te pelqy azboxi fik :D
1-Nderro kanalin dhe ktheje prap ne kanalin ku nuk ke za dhe shtyp 2 here tastin resolution dhe do funksionoj zeri, provo disa here nese nuk ke sukses heren e pare.
2-Ngecja e figures do rregullohet me rregullimin e zerit pasi kur zeri punon ngecje thuajse nuk ka fare.
Sigurisht qe ka edhe mjaft pune por duke e marr parasysh se si po punohet e2 per azbox mendoj se po perparohet me mjaft shpejtesi.
tung
Enigma 2 v1.0.29
Devices suitable for flashing : Elite and Premium
What is new :
- MyTube plugin (YouTube)
- Multimedia fix for various formats by sattomy
ATTENTION: Use AzUP v1.1 for Flashing this version of Enigma 2 into Your devices !!!
Code:
kshtu qe un jom ka e pres ni tuner qe e kom porosit edhe do e kallim Az-n :PCode:http://www.azbox-enigma.eu/?p=81
Dedea e porosita ni Tuner prej Portugali kshtu qe jom ka pres mem ardh
Install E2 on USB and leave dom untouched
NOTE: Changing from opensat to e2 and the otherway around involves using AZUP everytime.
What do you need:
-1 usb of at lest 512mb (for e2, possible 256 will work)
-1 usb for putting patch bin
#####FIRST TIME FLASHING E2######
-Put e2 patch.bin on usb and put this in the upper usb slot
-Reboot your azbox and follow onscreen instructions to install upgrade. This will only install new kernel. When done reboot (leave usb stick in the slot)
-Once rebooted box will show rescue mode and IP. DO NOT USE AZUP NOW
-Attach usb stick for e2 now (521mb or larger).
-Telnet to your box and issue the following commands:
dd if=/mnt/root/patch.bin of=/mnt/root/patch_cramfs.bin bs=56 =skip=1
mkdir /PATCH
mount -o loop patch_cramfs.bin /PATCH
sfdisk -f -uM /dev/sdb < /PATCH/hda.out
mkfs.ext3 /dev/sdb1
mkfs.ext2 /dev/sdb2
umount /MMP
mount /dev/sdb1 /MMP
cd /PATCH
tar -cf - . | tar -C / -xpf -
-Now remove usb stick with patch.bin on it and issue the following command:
reboot -f
-This should boot e2 from usb stick.
#####GOING BACK TO OPENSAT SOFTWARE#####
-Remove usb stick with e2, and place usb stick with opensat firmware patch.bin
-reboot box
-Run azup on your pc, and enter rescuemode ip.
-Click update.
-When done, remove usb stick from receiver and reboot
#####Go from OPENSAT to E2 after going back to opensat software#####
-Put in usb stick with e2 patch.bin -> only this one
-Reboot and follow onscreen instructions to upgrade
-Switch usb stick for the one with E2 and reboot
This should be it!
pėr momentin enigma 2 nuk ja vlen pėr azbox, ndoshta pas naj kohe..
e kam provuar vetėm sa i veshtirson gjėrat..sidomos me seting ?.