Flycccam - Cracked and Fully Working!

[grgam3r]

Here's a cracked version of Flycccam v0.3 b5 cracked and fully functional by Dahli.
Test.

[betatest]

Sorry for my question cause I'm a beginner. What channels can we open with flycccam plugins. I have Twinhan dvb card and using Vplug on hotbird.

Many thanks

[herrrr]

Sorry for my question cause I'm a beginner. What channels can we open with flycccam plugins. I have Twinhan dvb card and using Vplug on hotbird.

Many thanks

it depends on the cards online on the server you're using...

[betatest]

@herrrr

Many thanks for the quick reply. I've installed the plugin and I'm connected to the internet, what Flycccam can give me.

thank you

[herrrr]

@herrrr

Many thanks for the quick reply. I've installed the plugin and I'm connected to the internet, what Flycccam can give me.

thank you

do you have a dreambox and want to share one card working on it?
do you have friends that share one or more card with you?
...this is the only thing it works for...

[alexbg21]

Is there a way to reshare C line of FLYCCCAM over local network like MBOX plug-in?

[alexbg21]

OK, I did it. Server is DREAMBOX CCCAM plug-in configured with F: line
Client is SKYSTAR2 Progdvb with HADU CCCAM plug-in

[tintin2005]

hello everybody

i´m trying for long time to make hadu work whith my sshd2 and windows xp pro, but till now it didn´t work. flycccam works ok, i´ve adapted the same line i used n flycccam in hadu and in Acamd 0612 and get no resaults.
i´ll apreciate some help.

thanks in advance

tintin2005

[Lujdzo]

A new Version from FLYCCCAM v0.4 has been issued dated 17/10/2009

and here is the announcement from the site



It is mainly as previous versions with little changes


Sharing CCCam is mainly one line server or many lines servers
We put this (These) server(s) in a file called flyccam.cfg
using the NotePad of windows



After putting the server(s)
We start the program from a file called SSSP Plug.exe
and it is located in the main folder



then comes the advertisement scrren
and we close it



the the Monitor appears



Then we start the program and press CONNECT
the program will start and get the code



and we notice the Monitor and the code it brought



And in case the Monitor did not appear
You can show it yourself



It has to be noted that
the preparation in the Config page of the Humax 5400 is
Card+S+Emu
Ecm+Emm
SSSP

And you can use any software (Firmware) as you like
Starting from 7.5 till 11.1

I hope you keep Enjoying Humax 5400
Best regards and wishes

the program is Attached

patch FLYCCCAM